THANKS! That's what I needed. It was showing 28K vs. 45K, so I'll have to check everything because it didn't error during the ftp process.

Paula M. Adkins, Risk Analyst I Risk & Source Management Dept. CheckFree Corporation 6000 Perimeter Drive Dublin, OH 43017 614-564-3117, 614-564-4308-fax www.checkfree.com

"Valone, Toren W." To: "'PAdkins@CHECKFREE.COM'" <TValone@DMV. <PAdkins@CHECKFREE.COM> CA.gov> cc: Subject: RE: Mainframe ISPF Question 06/12/01 06:35 PM

Just go into edit and then go to the bottom of the file, that will give you a record count. I believe when you FTP it gives you a byte count.

-----Original Message----- From: Paula M. Adkins [mailto:PAdkins@CHECKFREE.COM] Sent: Tuesday, June 12, 2001 3:36 PM To: SAS-L@LISTSERV.UGA.EDU Subject: Mainframe ISPF Question

MVS-TSO Mainframe - Under 3.4 ISPF

Can someone tell me if there is a way to show/count the number of lines of data in a raw file that I sent via ftp? This file is going to be used in a SAS program, but I want to ensure I have all the records before I run it.

I'm using the Data Set List Utility under ISPF, then selecting "B" next to the file to browse it. I want to ensure the 45K records came over when I sent the file through the ftp process. I already closed MS-DOS so I can't see those results.

Thanks!

Paula M. Adkins, Risk Analyst I Risk & Source Management Dept. CheckFree Corporation 6000 Perimeter Drive Dublin, OH 43017 614-564-3117, 614-564-4308-fax www.checkfree.com